loading
reading
writing
saving
searching
Tree puller - $2,895 (Richmond)
27876 near 218th Ave
QR Code Link to This Post
We built our skid loader tree puller attachment to enable a single person to remove a tree completely. This attachment removes the tree and its roots in one pull for safe and efficient land clearing. Use the attached spade to loosen roots before pulling for the best results. Our tree pullers get the job done using some of the most reliable design features on the market. Its structural steel build, high operating capacity and safety features make the STP-34 an unmatched solution.
Approximate weight 450 lbs.
Constructed with grade 50 steel.
34” total jaw opening width.
42” long jaw length.
¾” thick jaws constructed with Grade 50 steel.
¾” thick jaws are fully welded.
Main pivot pin uses a 1-1/2” cold rolled steel shaft inside a 3/8” thick sidewall bushing.
All pivot points have easily accessible grease zerks.
Main frame constructed with 3”x3” square tubing.
3/8” gussets
Tree Guard fully welded to main frame to ensure operator safety.
6”x6”x3/4” spade on front for multiple uses and also improve the attachment’s versatility.
8”x3/4” flat bar at the end of the jaws that closes tight to pull small-diameter objects.
Conveniently located step on the left-hand side of the attachment for easy skid loader access.